Henning am 9. Dezember 2020 um 16:00 Uhr

2020-12-09T16:00:34Z

← Nächstältere Version		Version vom 9. Dezember 2020, 16:00 Uhr
Zeile 1:		Zeile 1:
			===== flashen: =====
			[[Datei:BW-SHP2.jpg\|rahmenlos]]
			[[Datei:BW-SHP2 flash modus.jpg\|rahmenlos]]
			<br>

			Zum einmaligen flashen GND und IO0 verbinden

	===== ESPhome config: =====		===== ESPhome config: =====

Henning: Die Seite wurde neu angelegt: „===== ESPhome config: ===== substitutions: plug_name: bw_shp2 # Higher value gives lower watt readout current_res: "0.0022…“

2020-08-23T10:32:34Z

Die Seite wurde neu angelegt: „===== ESPhome config: ===== <syntaxhighlight lang="YAML"> substitutions: plug_name: bw_shp2 # Higher value gives lower watt readout current_res: "0.0022…“

Neue Seite

===== ESPhome config: =====

<syntaxhighlight lang="YAML">
substitutions:
plug_name: bw_shp2
# Higher value gives lower watt readout
current_res: "0.00221"
# Lower value gives lower voltage readout
voltage_div: "934"

esphome:
name: ${plug_name}
platform: ESP8266
board: esp8285

wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
fast_connect: true

logger:

web_server:
port: 80

api:
password: !secret api_password

ota:
password: !secret ota_password

time:
- platform: homeassistant
id: homeassistant_time

binary_sensor:
- platform: gpio
pin:
number: GPIO3
inverted: True
name: "${plug_name}_Button"

switch:
- platform: gpio
name: "${plug_name}_Relay"
pin: GPIO14
restore_mode: ALWAYS_ON
- platform: gpio
name: "${plug_name}_LED_Blue"
pin: GPIO1
inverted: True
restore_mode: ALWAYS_OFF
- platform: gpio
name: "${plug_name}_LED_Red"
pin: GPIO13
inverted: True
restore_mode: ALWAYS_OFF

sensor:
- platform: hlw8012
sel_pin:
number: GPIO12
inverted: True
cf_pin: GPIO04
cf1_pin: GPIO05
current_resistor: ${current_res}
voltage_divider: ${voltage_div}
current:
name: "${plug_name}_Amperage"
unit_of_measurement: A
voltage:
name: "${plug_name}_Voltage"
unit_of_measurement: V
power:
name: "${plug_name}_Wattage"
unit_of_measurement: W
id: "${plug_name}_Wattage"
change_mode_every: 8
update_interval: 10s

- platform: total_daily_energy
name: "${plug_name}_Total Daily Energy"
power_id: "${plug_name}_Wattage"
filters:
- multiply: 0.001
unit_of_measurement: kWh

- platform: uptime
name: ${plug_name}_Uptime Sensor
</syntaxhighlight>

BW-SHP2 - Versionsgeschichte

Henning am 9. Dezember 2020 um 16:00 Uhr

Henning: Die Seite wurde neu angelegt: „===== ESPhome config: ===== substitutions: plug_name: bw_shp2 # Higher value gives lower watt readout current_res: "0.0022…“